N
Neil
I'm using a formview but have come across a frustrating problem.
If I have the width of the formview set to a specific size e.g. 960px I
can see all the template as it would be displayed to a user when in
design view. Sometimes it might not initially display like this but a
click on the right hand side handle of the control forces it to resize
according to the width property.
However, if I set the width to 100% I cannot get the template to
display correctly in design view, it is all compacted on the left hand
side. This makes attempting to add controls very difficult.
I know I could set a fixed width whilst designing and then change it to
100% but I shouldn't need to.
Is there a simple way around this problem?
If I have the width of the formview set to a specific size e.g. 960px I
can see all the template as it would be displayed to a user when in
design view. Sometimes it might not initially display like this but a
click on the right hand side handle of the control forces it to resize
according to the width property.
However, if I set the width to 100% I cannot get the template to
display correctly in design view, it is all compacted on the left hand
side. This makes attempting to add controls very difficult.
I know I could set a fixed width whilst designing and then change it to
100% but I shouldn't need to.
Is there a simple way around this problem?