Newbie Question: Using MaxIIplus how do you assign a bus to external pins.

Discussion in 'VHDL' started by Don Golding, Apr 14, 2004.

  1. Don Golding

    Don Golding Guest

    I have a bus in the Graphics Editor which is defined as bus(15..0) on a bus
    to a symbol I created.

    How do I assign each individual signal line to a specfic pin?

    Thanks,
    Don Golding
     
    Don Golding, Apr 14, 2004
    #1
    1. Advertisements

  2. For line 3, as an example, write bus3. This comes from the help file
    under index entry "buses, names".

    Charles B. Cameron
     
    Cameron, Charles B., Apr 15, 2004
    #2
    1. Advertisements

  3. Don Golding

    Leon Heller Guest

    Or bus[3], which I prefer.

    Leon
     
    Leon Heller, Apr 15, 2004
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.