P
Peter Afonin
Hello,
I've created an ASP.NET website and I'm trying to debug the stored procedure
from VS 2008 as described here:
http://articles.techrepublic.com.com/5100-10878_11-5161626.html.
I used to do this in the past without any problems, but now, when I set a
breakpoint in the stored procedure, I get an error:
"The breakpoint will not currently be hit. No symbols have been loaded for
this document".
This is a pretty common error and could have many causes, but I'd never seen
it when debugging the stored procedure. Now I'm getting this message in the
stored procedure only, if I set a breakpoint anywhere in my application
everything works fine.
I would appreciate your help.
Thank you,
Peter
I've created an ASP.NET website and I'm trying to debug the stored procedure
from VS 2008 as described here:
http://articles.techrepublic.com.com/5100-10878_11-5161626.html.
I used to do this in the past without any problems, but now, when I set a
breakpoint in the stored procedure, I get an error:
"The breakpoint will not currently be hit. No symbols have been loaded for
this document".
This is a pretty common error and could have many causes, but I'd never seen
it when debugging the stored procedure. Now I'm getting this message in the
stored procedure only, if I set a breakpoint anywhere in my application
everything works fine.
I would appreciate your help.
Thank you,
Peter